Arctic Cat 400 Service Manual page 338

7. Remove the spacers; then thoroughly clean all
parts in a high flash-point solvent.
Inspecting
1. Inspect the pulley faces for wear, galling, or
grooving.
2. Inspect the O-rings on the stationary face for
nicks, tears, or swelling.
3. Inspect two grease seals in the movable face for
nicks, cuts, or damage.
Back
3-294
KX283
KX577A
KX575A
Back to TOC
4. Inspect the pins, bushings, and cam slots for wear,
flat spots, looseness, or cracking.
Assembling
1. Apply multi-purpose grease to the O-rings and
grease seals on the movable face; then install on
the fixed face making sure the alignment marks
are properly aligned and the spacers are in posi-
tion.
2. Install the four pins into the fixed face hub; then
pack the cam slots in the movable face with
multi-purpose grease.
NOTE: Installation of the pins can be simplified
by applying a multi-purpose grease on the blade of
a screwdriver, placing the pin onto the grease, and
installing the pin into the appropriate slot; then fill-
ing the slot with grease to retain the pin in the slot.
Back to Section TOC
KX576A
KX579
KX578A
Next