Reverse Buzzer - Club Car Precedent 2004 Maintenance And Service

12
ELECTRICAL COMPONENTS
MCOR Installation
1. Secure the MCOR (2) to the pedal group with two hex-head screws (3) (Figure 12-7, Page 12-7).
Tighten screws to 23 in-lb (2.6 N·m).
2. Connect the two-pin and three-pin connectors (1) from the wire harness to the MCOR.
3. Install the pedal group. See Pedal Group Installation, Section 5, Page 5-6.
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.

REVERSE BUZZER

See General Warnings, Section 1, Page 1-1.
Testing the Reverse Buzzer
See Test Procedure 16, Section 11, Page 11-41.
Reverse Buzzer Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove instrument panel. See step 2 of Key Switch Removal on page 12-1.
3. Disconnect the 18-gauge pink and orange/white wires from reverse buzzer.
4. Remove the two screws from the reverse buzzer. Remove the reverse buzzer from the dash panel.
Reverse Buzzer Installation
1. Install the reverse buzzer in the reverse order of removal. Pink wire must be connected to the positive ter-
minal. Tighten screws to 4 in-lb (0.45 N·m).
2. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
Page 12-8 2004 Precedent IQ System Golf Car Maintenance and Service Manual
Reverse Buzzer