Governor Cable - Club Car 2005 FE290 Maintenance Service Supplement

14
FUEL SYSTEM
A
Accelerator Rod Installation and Adjustment, Continued:
Pull spring release to
install accelerator rod.
8. While pressing the accelerator pedal, the following events should occur in exactly the order shown:
EVENT
Park brake release
Solenoid activation
Carburetor throttle actuation
9. While holding the accelerator ball joint with pliers, tighten the jam nuts against the ball joints, accelerator
ball joint first, at each end of the accelerator rod.
10. Check rod adjustment for proper switch activation.
11. After the pedal group and accelerator rod are properly adjusted, adjust the engine RPM setting. See
Engine RPM Adjustment on page 14-11.
12. Install the electrical box cover and tighten retaining screw to 18 in-lb (2.0 N·m).
13. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.

GOVERNOR CABLE

Governor Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the
NEUTRAL position, and chock the wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
3. Remove the governor guard (5) (Figure 14-1, Page 14-3).
4. Disconnect the governor cable (2) at the carburetor throttle (Figure 14-7, Page 14-10).
Page 14-8 2005 FE290 Gasoline Vehicle Maintenance and Service Supplement
DS AND VILLAGER 4
Figure 14-6 Accelerator Rod
APPROXIMATE
PEDAL TRAVEL
0°-4°
4°-8°
8°-12°
3
Pull spring release to
install accelerator rod.
BOTTOM VIEW
Engine Control Linkage
TURF 1 AND CARRYALL 1
3