Low Oil Pressure Warning Light Switch - Triumph Tiger Service Manual

8 LUBRICATION
3. Locate the oil pump into the lower crankcase and
align it with the shaft.
1. Oil Pump Intermediate Gear
2. Oil Pump
4. Invert the crankcase and support the pump in
position.
5. Fit and tighten the oil pump screws to 12 Nm.
6. Refit the oil pump auxiliary gear and tighten the gear
fixing to 9 Nm.
7. Position the selector forks to the selector drum, in
the order noted during removal.
8. Support the selectors and feed the selector shaft
through the crankcase and selectors. Fit the shaft
keeper plate and tighten the retaining bolt to 6 Nm.
Inset:- Selector Shaft Keeper Plate
9. Refit the input and output shafts.
8.12
Low Oil Pressure Warning Light Switch
The low oil pressure warning light switch is located at the
lower end of the camshaft oil feed pipe.
1. Oil Feed Pipe
2. Low Oil Pressure Warning Light Switch
3. Electrical Connection/Covering Boot
1. Remove the seats and disconnect the battery
negative (black) lead first.
2. Lift the covering boot and disconnect the electrical
connection to the switch.
3. Remove the switch and collect the copper washers.
Installation
1. Using new copper washers, fit the switch and
tighten to 13 Nm.
2. Refit the electrical connection.
3. Refit the covering boot. .
4. Reconnect the battery, positive (red) lead first.
(
\