Tray 2 Paper Is Low - Xerox Phaser 6300 Service Manual

Troubleshooting Procedure Table
Step Actions and Questions
1 Has the shipping ribbon been completely
removed from the Toner Cartridge?
2
Does the error clear after Door A is opened
and closed?

Tray 2 Paper Is Low

The tray's Low Paper Sensor indicates a Low Paper condition.
Applicable Status Code:
Warning: Tray 2 is Low
Initial Actions:
Check that Tray 2 is at least half full of paper and free of obstructions.
Insert the tray and cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Low Paper Sensor, PL3.3.7
Low Paper Sensor Actuator, PL3.3.14
FDR Harness, PL3.3.22
Troubleshooting Procedure Table
Step Actions and Questions
1 Fill the tray with paper.
Does the error occur if the tray is full?
2 Check the following for evidence of fault or
damage:
Low Paper Sensor, PL3.3.7
Low Paper Actuator, PL3.3.14
Is there any damage?
3-46
Wiring and Plug/Jack References
Print Engine Map 4 - P/J Locator (page 10-8)
Print Engine Tray 2 Wiring (page 10-18)
Phaser 6300/6350 Color Laser Printer Service Manual
Yes
Go to Step 2.
Complete
Yes
Go to Step 2.
Replace any
damaged parts.
No
Remove the ribbon
and cycle printer
power.
Refer to "Install or
Lock [Y] [M] [C] [K]
Toner Cartridge"
on (page 3-41).
No
Complete
Go to Step 3.