Tray 2 Paper Is Low - Xerox Phaser 6250 Service Manual

Tray 2 Paper is Low

Remove Tray 2 and ensure that it is at least half full of paper.
Inspect the tray for obstructions or defects.
Reinstall the tray.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Low Paper Sensor, PL 3.3.4
Low Paper Lever, PL 3.2.7
Troubleshooting Procedures Table
Steps Actions and Questions
1 Fill the tray with paper.
Does the error occur if the tray is full?
2
Check the following for evidence of fault or
damage:
Low Paper Sensor; PL 3.3.4
Low Paper Lever, PL 3.2.7
3 Use service diagnostics to test the
Tray 2 Low Paper Sensor.
Do the sensor and actuator function
properly?
4
Verify the voltage between pins
P/J 47-10 <=> P/J 47-9 on the Motor Driver
Board is +3.3 VDC.
5 Verify the voltage between pins
P/J 42-20 <=> P/J 42-15 on the Motor
Driver Board is +3.3 VDC.
6
Verify the voltage between pins
P/J 47-8 <=> P/J 47-9 on the Motor Driver
Board is +3.3 VDC.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Paper Tray 2" on page 10-17
Yes
Go to Step [2].
Replace the parts
concerned.
Replace the
Engine Control
Board,
page 8-107.
Go to Step 6.
Replace the Motor
Driver Board,
page 8-101.
Replace the
Sensor No Paper,
page 8-30.
No
Complete
Go to Step 3.
Go to Step 4.
Go to Step 5.
Replace the
Engine Control
Board,
page 8-107.
Replace the
Motor Driver
Board,
page 8-101.
3-59