Finisher Lower Output Tray Is Full, Unload Paper - Xerox Paser 7400 Service Manual

Finisher Lower Output Tray is Full, Unload Paper

Initial Actions:
Ensure that the output tray is empty and the actuator is in the correct
position.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Saddle Stitch Bind Tray
Bind Tray Sensor Flag
Stapler
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault,
damage, obstruction, or debris:
Saddle Stitch Bind tray
Bind Tray Sensor Flag
Stapler
Are there any defects or misalignment?
2
Test the Binding Sensor.
Run the Service Diagnostics Bookbinding
Sensor tests.
Does the Binding Sensor function
correctly?
3 Test the sensor signal.
Does the voltage change on CN15-3
connector of the Finisher Control Board
when the sensor is actuated?
3-40
Wiring and Plug/Jack References
Options Map 7 Finisher Sensor Locator (1/2)
Options Finisher Controller to Sensors (2/3)
Phaser 7400 Color Printer Options Service Manual
Yes
Replace any
damaged parts.
Replace the Engine
Control Board (see
Book 1).
Replace the
Finisher Control
Board (page 5-46).
No
Go to Step 2.
Go to Step 3.
Either the sensor
or the wiring is
defective. Check
the resistance of
the wires and if no
problem is found
replace the sensor.