Replace Fuser or Fuser is at End of Life
The printer's front panel displays "Replace Fuser or Fuser is at End of Life". The
Fuser has been replaced and is firmly locked into position. Printer power has been
cycled and the error still appears.
Note:
The "Fuser is at End of Life" is a warning. "Replace Fuser"
is a hard stop.
Troubleshooting Reference Table
Applicable Parts
EEPROM Board, PL 10.1.16
CRUM Harness Assembly, PL 10.1.15
Troubleshooting Procedure Table
Steps
Actions and Questions
1
Check the connector to the Fuser
Assembly for damage.
2
Does the error recur after the Fuser has
been replaced with a new one?
3
Replace the EEPROM Board.
Does the error recur?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Laser Unit" on page 359
"Fuser Assembly" on page 358
Yes
Connect properly
or replace the
parts concerned.
Power cycle the
printer.
Go to step [3].
Troubleshoot
using the wiring
diagram "Fuser
Assembly" on
page 358
Replace the
Engine Control
Board, RRP 12.7.
No
Go to step [2].
Complete
Complete
53