Replace Fuser / Fuser Life - Xerox Phaser 6130 Service Manual

Replace Fuser / Fuser Life

Phaser 6130 Color Laser Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
5 Check the resistances of Temp. Sensor
in the Fuser
Remove the Fuser.
Warning: Start the operation after the
Fuser has cooled down.
Check the resistances across the
following pins of the removed Fuser.
J171-5 <=> J171-4
J171-6 <=> J171-8
J171-6 <=> J171-7
Can the resistances be measured?
(The resistances are 7 k-ohm at 180
degrees C).
The Fuser has reached end of life.
Applicable Chain Link
010-351: The Fuser is at end of life.
Troubleshooting Reference Table
Applicable Parts
Fuser (PL6.1.1)
MCU Board (PL8.2.13)
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the life counter value of the
Fuser
Does the life counter value show the
near of the end?
Error Messages and Codes
Yes No
Replace the Replace the
MCU Board Fuser
(page 8-59) (page 8-9).
After replacing
the Fuser, be
sure to reset the
life counter
value.
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-9
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Feeder, Manual Feed, & Registration" on
page 10-19
Yes No
Replace the Go to step 2.
Fuser
(page 8-9).
After replacing
the Fuser, be
sure to reset the
life counter
value.
3-63