Misfeed At Tray 1 (Mpt): Jam T1 - Xerox Phaser 6300 Service Manual

Misfeed at Tray 1 (MPT): Jam T1

Paper fed from Tray 1 (MPT) did not reach the Registration Sensor on time.
Applicable Status Code:
Code 155:
Misfeed at Tray 1
Initial Actions:
Ensure that Tray 1(MPT) is securely attached to the printer.
Try picking paper from a different tray.
Check the paper path for obstructions or debris.
Ensure that the media guides are set correctly.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feed Roller Assembly MPT, PL5.3.20
Interlock Switch, PL9.1.11
Registration Sensor, PL4.1.3
Feed Solenoid, PL5.3.9
Registration Roller Assembly, PL4.2.1
Main Drive Assembly, PL8.1.2
Troubleshooting Procedure Table
Step Actions and Questions
1
Check the following for evidence of fault or
damage:
Feed Roller Assembly MPT,
PL5.3.20
Tray 1 (MPT)
Registration Sensor, PL4.1.3
Main Drive Assembly, PL8.1.2
Remove any foreign objects or paper
debris from the paper path.
Is there any damage?
2 Test the Registration Sensor.
Run the Service Diagnostics Registration
Sensor test.
Does the sensor function correctly?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 1 P/J Locator (page 10-5)
Print Engine Power Wiring Diagram (page 10-17)
Print Engine Drive Wiring Diagram (page 10-19)
Print Engine Paper Feed Wiring (page 10-26)
Yes
Replace any
damaged or
excessively worn
parts.
Go to Step 6.
No
Go to Step 2.
Go to Step 3.
3-17