Jam At Tray 1 (Mpt) - Xerox Phaser 6180 Service Manual

Error Messages and Codes

Jam at Tray 1 (MPT)

Applicable Chain Link
Initial Actions
3-18
Paper fed from Tray 1 (MPT) did not reach the Registration Sensor on time.
■
Chain Link 075-100: Jam at Tray 1
■
Try picking paper from a different tray.
■ Check the paper path for obstructions or debris.
■
Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.1.20
■
Tray 1 (MPT) Retard Holder Kit,
■
PL2.1.3
MPT Feed Roll, PL3.1.10
■
Tray 1 Feed Solenoid, PL3.1.3
■
Turn Roll, PL3.2.32
■
Feeder Unit, PL3.2.1
■
Registration Sensor Harness,
■
PL3.2.37
Right Side Harness, PL10.1.15
■
Turn Clutch, PL3.2.25
■
Drive Assembly, PL8.1.7
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the paper condition. Is the
paper damaged?
Check the paper setting. Does the
2
paper in use match with the paper
settings on the Control Panel?
Does the error still occur?
3
Reseat the Tray 1 Side Guides. Does
4
the error still occur?
Wiring and Plug/Jack Map Reference
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Tray 1 (MPT) and Registration" on
■
page 10-32
"Feeder" on page 10-36
■
Yes
Replace the
paper.
Go to step 3.
Go to step 4.
Go to step 5.
Phaser 6180 Color Laser Printer Service Manual
No
Go to step 2.
Correct the
paper settings
on the Control
Panel. Go to
step 3.
Complete.
Complete.