Honda 2004 Odyssey Service Manual page 464

8. Turn the ignition switch OFF.
9. Disconnect PCM connector E (31P).
10. Check for continuity between body ground and
PCM connector terminal E19.
PCM CONNECTOR E (31P)
Wire side of female terminals
Is there continuity?
YES Repair short in the wire between the PCM
(E19) and the ELD.
NO Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
DTC P1298 '99-00, '02-04 Models:
Circuit High Voltage
1. Reset the PCM (see page 11-4).
2. Start the engine.
3. Turn on the headlights.
ELD (GRN/RED)
4. Turn the ignition switch and headlights OFF.
5. Disconnect the ELD 3P connector.
6. Turn the ignition switch ON (II).
7. Measure voltage between body ground and ELD 3P
8. Turn the ignition switch OFF.
Is DT C P1298 indicated?
YES Go to step 4.
NO Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the ELD and the PCM.
connector terminal No. 1.
ELD 3P CONNECTOR
IG1 (BLK/YEL)
Wire side of female terminals
Is there battery voltage?
YES Go to step 8.
NO Check the No. 6 ECU (PCM) CRUISE
CONTROL (15A) fuse in the driver's under-dash
fuse/relay box. If the fuse is OK, repair open in the
wire between the No. 6 ECU (PCM) CRUISE
CONTROL (15A) fuse and the ELD.
ELD
(cont'd)
11-155 11-155