Policy Route Edit Screen - ZyXEL Communications ZyWall USG 2000 User Manual

Unified security gateway

Hide thumbs Also See for ZyWall USG 2000:

Table of Contents

Table 71 Network > Routing > Policy Route (continued)

12.2.1 Policy Route Edit Screen

Click Network > Routing to open the Policy Route screen. Then click the Add

or Edit icon to open the Policy Route Edit screen. Use this screen to configure or

edit a policy route.

ZyWALL USG 2000 User's Guide

This is the next hop to which packets are directed. It helps forward

packets to their destinations and can be a router, VPN tunnel, outgoing

interface or trunk.

This is the source IP address that the route uses.

It displays none if the ZyWALL does not perform NAT for this route.

This is the maximum bandwidth allotted to the policy. 0 means there is

no bandwidth limitation for this route.

Click the Add icon in the heading row to add a new first entry.

The Active icon displays whether the rule is enabled or not. Click the

Active icon to activate or deactivate the policy. Make sure you click

Apply to save and apply the change.

Click the Edit icon to go to the screen where you can edit the routing

policy on the ZyWALL.

Click the Add icon in an entry to add a rule below the current entry.

Click the Remove icon to delete an existing routing policy from the

ZyWALL. A window displays asking you to confirm that you want to delete

the routing policy.

In a numbered list, click the Move to N icon to display a field to type a

number for where you want to put that rule and press [ENTER] to move

the rule to the number that you typed.

The ordering of your rules is important as they are applied in order of

their numbering.

Click Apply to save your changes back to the ZyWALL.

Click Reset to begin configuring this screen afresh.

Chapter 12 Policy and Static Routes

Zywall usg 1000