Ip Static Route Screen - ZyXEL Communications ZyWall USG 2000 User Manual

Unified security gateway

Hide thumbs Also See for ZyWall USG 2000:

Table of Contents

Table 72 Network > Routing > Policy Route > Edit (continued)

12.3 IP Static Route Screen

Click Network > Routing > Static Route to open the Static Route screen. This

screen displays the configured static routes. Configure static routes to be able to

use RIP or OSPF to propagate the routing information to other routers.

Figure 150 Network > Routing > Static Route

ZyWALL USG 2000 User's Guide

Specify the maximum bandwidth (from 1 to 1048576) allowed for the

route in kbps. If you enter 0 here, there is no bandwidth limitation for

If the sum of the bandwidths for routes using the same next hop is

higher than the actual transmission speed, lower priority traffic may not

be sent if higher priority traffic uses all of the actual bandwidth.

To reserve bandwidth for traffic that does not match any of the policy

routes, leave some of the interface's bandwidth unbudgeted and do not

enable Maximize Bandwidth Usage.

Enter a number between 1 and 7 to set the priority for traffic. The

smaller the number, the higher the priority. If you set the maximum

bandwidth to 0, the bandwidth priority will be changed to 0 after you

click OK. That means the route has the highest priority and will get all

the bandwidth it needs up to the maximum available.

A route with higher priority is given bandwidth before a route with lower

If you set routes to have the same priority, then bandwidth is divided

equally amongst those routes.

Select this check box to have the ZyWALL divide up all of the interface's

unallocated and/or unused bandwidth among the policy routes that

require bandwidth. Do not select this if you want to reserve bandwidth

for traffic that does not match any of the policy routes.

Click OK to save your changes back to the ZyWALL.

Click Cancel to exit this screen without saving.

Chapter 12 Policy and Static Routes

Zywall usg 1000