ZyXEL Communications ZyWall USG 2000 User Manual page 608

Chapter 36 Device HA
The Device HA Legacy Mode Add or Edit screen lets you configure a VRRP
group. To access this screen, click Device HA > Legacy Mode > Add (or Edit).
Figure 409 Device HA > Legacy Mode > Add
The following table describes the labels in this screen.
Table 180 Device HA > Legacy Mode > Add
LABEL
Enable VRRP
Group
Name
Description
Interface
Name
Manage IP
Subnet Mask
608
DESCRIPTION
Select this to make the specified interface part of the virtual router.
Clear this to take the specified interface out of the virtual router.
Enabling a VRRP group has the ZyWALL monitor the connection of the
group's interface.
This field is read-only if you are editing the VRRP group. Type the name
of the VRRP group. This field must be unique in the ZyWALL, but it is not
used in the virtual router. The virtual router uses the VRID. The name
can consist of alphanumeric characters, the underscore, and the dash
and may be up to fifteen characters long.
Type the description of the VRRP group. This field is only for your
reference. It may be up to sixty printable ASCII characters long.
Select the interface in this device that is part of the virtual router. You
can only select interfaces that have static IP addresses. Connect the
interface to the same subnet as the group's interface on the other
ZyWALL.
Enter the interface's IP address for management access. You can use
this IP address to access the ZyWALL whether it is the master or a
backup. This management IP address should be in the same subnet as
the interface IP address so the backup ZyWALL cannot synchronize with
the master via this VRRP interface.
Enter the subnet mask of the interface's management IP address.
ZyWALL USG 2000 User's Guide