Chapter 10 Interfaces
Table 61 Network > Interface > Bridge (continued)
LABEL
Add icon
Apply
Reset
10.10.2 Bridge Add/Edit
This screen lets you configure IP address assignment, interface bandwidth
parameters, DHCP settings, and connectivity check for each bridge interface. To
access this screen, click the Add icon at the top of the Add column in the Bridge
Summary screen, or click an Edit icon in the Bridge Summary screen. The
following screen appears.
Figure 137 Network > Interface > Bridge > Edit
212
DESCRIPTION
This column lets you create, edit, remove, activate, and deactivate
interfaces.
To create a bridge interface, click the Add icon at the top of the
column. The Bridge Add/Edit screen appears.
To create a virtual interface, click the Add icon next to the
corresponding bridge interface. The Virtual Interface Add/Edit
screen appears. See
Section 10.12 on page
To edit an interface, click the Edit icon next to it. The Bridge Add/
Edit screen or Virtual Interface Add/Edit screen appears
accordingly.
To remove an interface, click the Remove icon next to it. The
ZyWALL confirms you want to remove it before doing so.
To activate or deactivate an interface, click the Active icon next to it.
Make sure you click Apply to save and apply the change.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
219.
ZyWALL USG 2000 User's Guide