Secure Telnet Using Ssh Examples - ZyXEL Communications ZyWall USG 2000 User Manual

The following table describes the labels in this screen.
Table 234 System > SSH
LABEL
Enable
Version 1
Server Port
Server
Certificate
Service Control This specifies from which computers you can access which ZyWALL
#
Zone
Address
Action
Add icon
Apply
Reset

46.7.5 Secure Telnet Using SSH Examples

This section shows two examples using a command interface and a graphical
interface SSH client program to remotely access the ZyWALL. The configuration
and connection steps are similar for most SSH client programs. Refer to your SSH
client program user's guide.
ZyWALL USG 2000 User's Guide
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the ZyWALL CLI using this service.
Select the check box to have the ZyWALL use both SSH version 1 and
version 2 protocols. If you clear the check box, the ZyWALL uses only
SSH version 2 protocol.
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Select the certificate whose corresponding private key is to be used to
identify the ZyWALL for SSH connections. You must have certificates
already configured in the My Certificates screen (Click My Certificates
and see Chapter 43 on page 665
zones.
This the index number of the service control rule.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is
allowed or denied to access.
This displays whether the computer with the IP address specified above
can access the ZyWALL zone(s) configured in the Zone field (Accept) or
not (Deny).
Click the Add icon in the heading row to open a screen where you can
add a new rule. Refer to
fields.
Click the Edit icon to go to the screen where you can edit the rule.
Click the Add icon in an entry to add a rule below the current entry.
Click the Delete icon to remove an existing rule. A window display
asking you to confirm that you want to delete the rule. Note that
subsequent rules move up by one when you take this action.
Click the Move to N icon to display a field to type a number for where
you want to put that rule and press [ENTER] to move the rule to the
number that you typed.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
for details).
Table 232 on page 720 for information on the
Chapter 46 System
735