ZyXEL Communications ZyWall USG 2000 User Manual page 241

Table 72 Network > Routing > Policy Route > Edit (continued)
LABEL
Schedule
Service
Next-Hop
Type
Gateway
VPN Tunnel
Auto
Destination
Address
Trunk
Interface
Address
Translation
ZyWALL USG 2000 User's Guide
DESCRIPTION
Select a schedule or select Create Object to configure a new one (see
Chapter 40 on page 643
all times if enabled.
Select a service or service group from the drop-down list box. Select
Create Object to add a new service. See
for more information.
Select Auto to have the ZyWALL use the routing table to find a next-
hop and forward the matched packets automatically.
Select Gateway to route the matched packets to the next-hop router or
switch you specified in the Gateway field. You have to set up the next-
hop router or switch as a HOST address object first.
Select VPN Tunnel to route the matched packets via the specified VPN
tunnel.
Select Trunk to route the matched packets through the interfaces in the
trunk group based on the load balancing algorithm.
Select Interface to route the matched packets through the specified
outgoing interface to a gateway (which is connected to the interface).
This field displays when you select Gateway in the Type field. Select a
HOST address object. The gateway is an immediate neighbor of your
ZyWALL that will forward the packet to the destination. The gateway
must be a router or switch on the same segment as your ZyWALL's
interface(s).
This field displays when you select VPN Tunnel in the Type field. Select
a VPN tunnel through which the packets are sent to the remote network
that is connected to the ZyWALL directly.
This field displays when you select VPN Tunnel in the Type field. Select
this to have the ZyWALL use the local network of the peer router that
initiated an incoming dynamic IPSec tunnel as the destination address of
the policy.
Leave this cleared if you want to manually specify the destination
address.
This field displays when you select Trunk in the Type field. Select a
trunk group to have the ZyWALL send the packets via the interfaces in
the group.
This field displays when you select Interface in the Type field. Select
an interface to have the ZyWALL send traffic that matches the policy
route through the specified interface.
Use this section to configure NAT for the policy route. This section does
not apply to policy routes that use a VPN tunnel as the next hop.
Chapter 12 Policy and Static Routes
for details). none means the route is active at
Section 39.2.1 on page 640
241