ZyXEL Communications ZyWall USG 2000 User Manual page 218

Chapter 10 Interfaces
Table 63 Network > Interface > Auxiliary (continued)
LABEL
Zone
Description
Port Speed
Dialing Type
Initial String
Auxiliary
Configuration
Phone Number Enter the phone number to dial here. You can use 1-20 numbers,
User Name
Password
Retype to
confirm
Authentication
Type
Timeout
Idle timeout
Apply
Reset
218
DESCRIPTION
This field is read-only and displays the zone to which the auxiliary
interface belongs.
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
Select the speed of the connection between the ZyWALL and external
computer.
Tone - select this if the telephone uses tone-based dialing.
Pulse - select this if the telephone uses pulse-based dialing.
Enter the AT command string to initialize the external modem.
the most common string, but you should check the manual for the
external modem for additional commands.
commas (,), or plus signs (+). Use a comma to pause during dialing.
Use a plus sign to tell the external modem to make an international
call.
Enter the user name required for authentication.
Enter the password required for authentication.
Enter the password again to make sure you have not typed it
incorrectly.
Select the authentication protocol to use for outgoing calls. Choices
are:
CHAP/PAP - Your ZyWALL accepts either CHAP (Challenge
Handshake Authentication Protocol) or PAP (Password Authentication
Protocol), as requested by the computer you are dialing.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
Type the number of seconds the ZyWALL tries to set up a connection
before it stops. Allowed values are 30 - 120.
Type the number of seconds the ZyWALL should wait for traffic before
it automatically disconnects the connection. Set this field to zero to
disable the idle timeout. Allowed values are 0 - 360.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
characters, and it can be
ZyWALL USG 2000 User's Guide
is
ATZ