ZyXEL Communications ZyWall USG 2000 User Manual page 462

Chapter 29 Application Patrol
Table 132 AppPatrol > Other (continued)
LABEL
BWM
Log
Add icon
Apply
Reset
462
DESCRIPTION
These fields show the amount of bandwidth the traffic can use. These
fields only apply when Access is set to forward.
In - This is how much inbound bandwidth, in kilobits per second, this
policy allows the matching traffic to use. Inbound refers to the traffic the
ZyWALL sends to a connection's initiator. If no displays here, this policy
does not apply bandwidth management for the inbound traffic.
Out - This is how much outgoing bandwidth, in kilobits per second, this
policy allows the matching traffic to use. Outbound refers to the traffic
the ZyWALL sends out from a connection's initiator. If no displays here,
this policy does not apply bandwidth management for the outbound
traffic.
Pri - This is the priority for the traffic that matches this policy. The
smaller the number, the higher the priority. Traffic with a higher priority
is given bandwidth before traffic with a lower priority. The ZyWALL
ignores this number if the incoming and outgoing limits are both set to
0. In this case the traffic is automatically treated as being set to the
lowest priority (7) regardless of this field's configuration.
Select whether to have the ZyWALL generate a log (log), log and alert
(log alert) or neither (no) when traffic matches this policy. See
48 on page 763 for more on logs.
Click the Add icon in the heading row to add a new first entry.
The Active icon displays whether the entry is enabled or not. Click the
Active icon to activate or deactivate the entry. Make sure you click
Apply to save and apply the change.
Click the Edit icon to go to the screen where you can edit the entry.
Click the Add icon in an entry to add a new entry below the current
entry.
Click the Remove icon to delete an existing entry from the ZyWALL. A
window displays asking you to confirm that you want to delete the entry.
To move an entry up or down in the list, click on the Move to N icon
next to the entry, and type the line number (# field) of where you want
to move the entry. The # field is updated accordingly. The ordering of
the entries is important as they are applied in order of their numbering.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter
ZyWALL USG 2000 User's Guide