Configuring A Group Of Radius Servers - ZyXEL Communications ZyWall USG 2000 User Manual

The following table describes the labels in this screen.
Table 205 Object > AAA Server > RADIUS > Default
LABEL
Host
Authentication
Port
Key
Timeout
Apply
Reset

41.5 Configuring a Group of RADIUS Servers

You can configure a group of RADIUS servers in the RADIUS > Group screen.
This is useful if you have more than one authentication server for user
authentication in a network.
Click Object > AAA Server > RADIUS > Group to display the RADIUS >
Group screen.
Figure 440 Object > AAA Server > RADIUS > Group
The following table describes the labels in this screen.
Table 206 Object > AAA Server > RADIUS > Group
LABEL
#
ZyWALL USG 2000 User's Guide
DESCRIPTION
Enter the IP address (in dotted decimal notation) or the domain name (up
to 63 alphanumeric characters) of a RADIUS server.
The default port of the RADIUS server for authentication is 1812.
You need not change this value unless your network administrator
instructs you to do so with additional information.
Enter a password (up to 15 alphanumeric characters) as the key to be
shared between the external authentication server and the ZyWALL.
The key is not sent over the network. This key must be the same on the
external authentication server and the ZyWALL.
Specify the timeout period (between 1 and 300 seconds) before the
ZyWALL disconnects from the RADIUS server. In this case, user
authentication fails.
Search timeout occurs when either the user information is not in the
RADIUS server or the RADIUS server is down.
Click Apply to save the changes.
Click Reset to start configuring this screen again.
DESCRIPTION
This field displays the index number.
Chapter 41 AAA Server
657