Address Add/Edit Screen - ZyXEL Communications ZyWall USG 2000 User Manual

38.2.1 Address Add/Edit Screen

The Address Add/Edit screen allows you to create a new address or edit an
existing one. To access this screen, go to the Address screen (see
on page 631), and click either the Add icon or an Edit icon.
Figure 423 Object > Address > Address > Edit
The following table describes the labels in this screen.
Table 192 Object > Address > Address > Edit
LABEL
Name
Address Type
IP Address
Starting IP
Address
Ending IP
Address
Network
Netmask
Interface
ZyWALL USG 2000 User's Guide
DESCRIPTION
Type the name used to refer to the address. You may use 1-31
alphanumeric characters, underscores(
character cannot be a number. This value is case-sensitive.
Select the type of address you want to create. Choices are: HOST,
RANGE, SUBNET, INTERFACE IP, INTERFACE SUBNET, and
INTERFACE GATEWAY.
Note: The ZyWALL automatically updates address objects that are
based on an interface's IP address, subnet, or gateway if the
interface's IP address settings change. For example, if you
change ge1's IP address, the ZyWALL automatically updates
the corresponding interface-based, LAN subnet address
object.
This field is only available if the Address Type is HOST. This field
cannot be blank. Enter the IP address that this address object
represents.
This field is only available if the Address Type is RANGE. This field
cannot be blank. Enter the beginning of the range of IP addresses that
this address object represents.
This field is only available if the Address Type is RANGE. This field
cannot be blank. Enter the end of the range of IP address that this
address object represents.
This field is only available if the Address Type is SUBNET, in which
case this field cannot be blank. Enter the IP address of the network that
this address object represents.
This field is only available if the Address Type is SUBNET, in which
case this field cannot be blank. Enter the subnet mask of the network
that this address object represents. Use dotted decimal format.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE
GATEWAY as the Address Type, use this field to select the interface of
the network that this address object represents.
Chapter 38 Addresses
Section 38.2
), or dashes (-), but the first
_
633