ZyXEL Communications ZyWall USG 2000 User Manual page 868

Appendix A Log Descriptions
Table 289 Interface Logs (continued)
LOG MESSAGE
Interface %s connect
failed: MS-CHAP
authentication
failed.
Interface %s connect
failed: CHAP
authentication
failed.
Interface %s is
connected.
Interface %s is
disconnected.
Interface %s connect
failed: Peer not
responding.
Interface %s connect
failed: PAP
authentication
failed.
Interface %s connect
failed: Connect
timeout.
Interface %s create
failed because has no
member.
"Interface cellular
Application Error Code
%d\n.
"An error [%d]
occurred while
negotiating with the
device in %s. Please
try to remove then
insert the device.
"Unable to negotiate
with the device in %s.
Please try to remove
then insert the
device.
"Unable to configure
the selected frequency
band to the device in
%s. Please try to
remove then insert the
device.
"PIN code is required
for inteface
cellular%d. Please
check the PIN code
setting.
868
DESCRIPTION
MS-CHAP authentication failed (the server must support MS-
CHAP and verify that the authentication failed, this does not
include cases where the server does not support MS-CHAP).
%s: interface name.
CHAP authentication failed (the server must support CHAP
and verify that the authentication failed, this does not include
cases where the server does not support CHAP). CHAP:
interface name.
A PPP or AUX interface connected successfully. %s: interface
name.
A PPP or AUX interface disconnected successfully. %s:
interface name.
The interface's connection will be terminated because the
server did not send any LCP packets. %s: interface name.
PAP authentication failed (the server must support PAP and
verify verify that the authentication failed, this does not
include cases where the server does not support PAP). %s:
PPP interface name.
A PPPOE connection timed out due to a lack of response from
the PPPOE server. %s: PPP interface name.
A bridge interface has no member. %s: bridge interface
name.
The listed error code (%d) was generated due to an internal
cellular interface error.
The listed error code (%d) happened when the ZyWALL
attempted to negotiate with the cellular device installed in (or
connected to) the listed slot (%s). Remove and reinstall the
device.
The ZyWALL could not negotiate with the cellular device
installed in (or connected to) the listed slot (%s). Remove
and reinstall the device.
The ZyWALL failed to set the cellular device installed in (or
connected to) the listed slot (%s) to use the frequency band
you configured. The cellular device may not support the band
or you may need to try removing and reinstalling the device.
The PIN code configured for the listed cellular interface (%d)
is incorrect or missing.
ZyWALL USG 2000 User's Guide