ZyXEL Communications ZyWall USG 2000 User Manual page 206

Chapter 10 Interfaces
Table 57 Network > Interface > VLAN > Edit (continued)
LABEL
Interface
Properties
Interface
Name
Base Port
VLAN ID
Description
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
Metric
Interface
Parameters
Egress
Bandwidth
206
DESCRIPTION
This field is read-only if you are editing an existing VLAN interface.
Enter the number of the VLAN interface. You can use a number from
0~4094. See Chapter 53 on page 805
number of VLANs you can configure on the ZyWALL. For example,
vlan0, vlan8, and so on.
Select the Ethernet interface on which the VLAN interface runs.
Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN.
Allowed values are 1 - 4094. (0 and 4095 are reserved.)
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
Select this if this interface is a DHCP client. In this case, the DHCP
server configures the IP address, subnet mask, and gateway
automatically.
You should not select this if the interface is assigned to a VRRP group.
See Chapter 36 on page
Select this if you want to specify the IP address, subnet mask, and
gateway manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The
subnet mask indicates what part of the IP address is the same for all
computers in the network.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The ZyWALL sends packets to
the gateway when it does not know how to route the packet to its
destination. The gateway should be on the same network as the
interface.
Enter the priority of the gateway (if any) on this interface. The
ZyWALL decides which gateway to use based on this priority. The
lower the number, the higher the priority. If two or more gateways
have the same priority, the ZyWALL uses the one that was configured
first.
Enter the maximum amount of traffic, in kilobits per second, the
ZyWALL can send through the interface to the network. Allowed
values are 0 - 1048576.
the User's Guide for the total
characters, and it can be
595.
ZyWALL USG 2000 User's Guide