L2Tp Vpn Screen - ZyXEL Communications ZyWall USG 2000 User Manual

Finding Out More
• See Section 5.4.6 on page 92
• See Chapter 28 on page 413
tunnel.

27.2 L2TP VPN Screen

Click VPN > L2TP VPN to open the following screen. Use this screen to configure
the ZyWALL's L2TP VPN settings.
Note: Disconnect any existing L2TP VPN sessions before modifying L2TP VPN
settings. The remote users must make any needed matching configuration
changes and re-establish the sessions using the new settings.
Figure 267 VPN > L2TP VPN
The following table describes the fields in this screen.
Table 122 VPN > IPSec VPN > VPN Connection
LABEL
Enable L2TP
Over IPSec
VPN Connection
IP Address Pool
ZyWALL USG 2000 User's Guide
for related information on these screens.
for an example of how to create a basic L2TP VPN
DESCRIPTION
Use this field to turn the ZyWALL's L2TP VPN function on or off.
Select the IPSec VPN connection the ZyWALL uses for L2TP VPN. All of
the configured VPN connections display here, but the one you use must
meet the requirements listed in
VPN on page 407.
Note: Modifying this VPN connection (or the VPN gateway that it
uses) disconnects any existing L2TP VPN sessions.
Select the pool of IP addresses that the ZyWALL uses to assign to the
L2TP VPN clients. Select Create Object to configure a new pool of IP
addresses.
Chapter 27 L2TP VPN
IPSec Configuration Required for L2TP
409