Ftp - ZyXEL Communications ZyWall USG 2000 User Manual

Chapter 46 System
The following table describes the labels in this screen.
Table 235 System > Telnet
LABEL
Enable
Server Port
Service
Control
#
Zone
Address
Action
Add icon
Apply
Reset

46.9 FTP

You can upload and download the ZyWALL's firmware and configuration files using
FTP. To use this feature, your computer must have an FTP client. Please see
Chapter 47 on page 751
files.
738
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the ZyWALL CLI using this service.
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
This specifies from which computers you can access which ZyWALL
zones.
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL's (non-
configurable) default policy. The ZyWALL applies this to traffic that does
not match any other configured rule. It is not an editable rule. To apply
other behavior, configure a rule that traffic will match so the ZyWALL will
not have to use the default policy.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is
allowed or denied to access.
This displays whether the computer with the IP address specified above
can access the ZyWALL zone(s) configured in the Zone field (Accept) or
not (Deny).
Click the Add icon in the heading row to open a screen where you can
add a new rule. Refer to
fields.
Click the Edit icon to go to the screen where you can edit the rule.
Click the Add icon in an entry to add a rule below the current entry.
Click the Delete icon to remove an existing rule. A window display
asking you to confirm that you want to delete the rule. Note that
subsequent rules move up by one when you take this action.
Click the Move to N icon to display a field to type a number for where
you want to put that rule and press [ENTER] to move the rule to the
number that you typed.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
for more information about firmware and configuration
Table 232 on page 720 for information on the
ZyWALL USG 2000 User's Guide