ZyXEL Communications ZyWall USG 2000 User Manual page 140

Chapter 7 Status
Table 29 Status (continued)
LABEL
Status
HA Status
Zone
IP Address
140
DESCRIPTION
This field displays the current status of each interface. The possible
values depend on what type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected.
This field displays the port speed and duplex setting (Full or Half).
Port Group Inactive - The Ethernet interface does not have any
physical ports associated with it.
Port Group Up - The Ethernet interface is part of a port group and is
connected.
Port Group Down - The Ethernet interface is part of a port group and is
not connected.
For cellular (3G) interfaces, see
that can appear.
For the auxiliary interface:
Inactive - The auxiliary interface is disabled.
Connected - The auxiliary interface is enabled and connected.
Disconnected - The auxiliary interface is not connected.
This field displays the status of the interface in the virtual router.
Active - This interface is the master interface in the virtual router.
Stand-By - This interface is a backup interface in the virtual router.
Fault - This VRRP group is not functioning in the virtual router right
now. For example, this might happen if the interface is down.
n/a - Device HA is not active on the interface.
This field displays the zone to which the interface is currently assigned.
This field displays the current IP address assigned to the interface. If the
IP address is 0.0.0.0, the interface is disabled or did not receive an IP
address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays
the IP address it is currently using. This is either the static IP address of
the interface (if it is the master) or the management IP address (if it is a
backup).
Section 10.8 on page 199
ZyWALL USG 2000 User's Guide
for the status