The ZyWALL uses the auxiliary interface to dial out in two situations.
You click the Connect icon on the ZyWALL Status screen.
1
The load auxiliary interface must connect to satisfy load-balancing requirements.
2
You have to add the auxiliary interface to a trunk first.
When the ZyWALL hangs up the call, it drops the Data Terminal Ready (DTR)
signal and issues the command ATH.
10.11.2 Auxiliary
Use the Auxiliary screen to configure the ZyWALL's auxiliary interface. Click
Network > Interface > Auxiliary to open it.
Figure 138 Network > Interface > Auxiliary
Each field is described in the table below.
Table 63 Network > Interface > Auxiliary
LABEL
General Settings
Enable
Interface
Interface
Properties
ZyWALL USG 2000 User's Guide
DESCRIPTION
Select this to turn on the auxiliary dial up interface. The interface
does not dial out, however, unless it is part of a trunk and load-
balancing conditions are satisfied.
Chapter 10 Interfaces
217