Bridge Add/Edit - ZyXEL Communications ZyWall USG20-VPN User Manual

Table 80 Configuration > Network > Interface > Bridge (continued)
LABEL
Object References
#
Status
Name
IP Address
Member
Apply
Reset

9.8.2 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP
settings, and connectivity check for each bridge interface. To access this screen, click the Add or
Edit icon in the Bridge Summary screen. The following screen appears.
Chapter 9 Interfaces
DESCRIPTION
Select an entry and click Object Reference to open a screen that shows which
settings use the entry. See
This field is a sequential value, and it is not associated with any interface.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field displays the name of the interface.
This field displays the current IP address of the interface. If the IP address is 0.0.0.0,
the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (STATIC) or
dynamically assigned (DHCP). IP addresses are always static in virtual interfaces.
This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface. It
is blank for virtual interfaces.
Click Apply to save your changes back to the USG.
Click Reset to return the screen to its last-saved settings.
USG20(W)-VPN Series User's Guide
205
Section 9.3.2 on page 164 for an example.