Bridge Interface Add/Edit - ZyXEL Communications UAG5100 User Manual

Table 78 Configuration > Network > Interface > Bridge (continued)
LABEL
Activate
Inactivate
Create Virtual
Interface
Object Reference
#
Status
Name
IP Address
Member
Apply
Reset

10.6.2 Bridge Interface Add/Edit

This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP
settings, and connectivity check for each bridge interface. To access this screen, click the Add icon,
or select an entry in the Bridge summary screen and click the Edit icon. The following screen
appears.
Chapter 10 Interfaces
DESCRIPTION
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To open the screen where you can create a virtual interface, select an interface and
click Create Virtual Interface.
Select an entry and click Object Reference to open a screen that shows which settings
use the entry. See Section 10.3.2 on page 165
This field is a sequential value, and it is not associated with any interface.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field displays the name of the interface.
This field displays the current IP address of the interface. If the IP address is 0.0.0.0,
the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (STATIC) or
dynamically assigned (DHCP). IP addresses are always static in virtual interfaces.
This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface. It
is blank for virtual interfaces.
Click Apply to save your changes back to the UAG.
Click Reset to return the screen to its last-saved settings.
UAG Series User's Guide
184
for an example.