Bridge Add/Edit - ZyXEL Communications ZyWALL USG 300 User Manual

Unified security gateway

Hide thumbs Also See for ZyWALL USG 300:

Table of Contents

Each field is described in the following table.

Table 68 Network > Interface > Bridge

10.13.2 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth

parameters, DHCP settings, and connectivity check for each bridge interface. To

access this screen, click the Add icon at the top of the Add column in the Bridge

ZyWALL USG 300 User's Guide

This field is a sequential value, and it is not associated with any

This field displays the name of the interface.

This field displays the current IP address of the interface. If the IP

address is 0.0.0.0, the interface does not have an IP address yet.

This screen also shows whether the IP address is a static IP address

(STATIC) or dynamically assigned (DHCP). IP addresses are always

static in virtual interfaces.

This field displays the Ethernet interfaces and VLAN interfaces in the

bridge interface. It is blank for virtual interfaces.

This column lets you create, edit, remove, activate, and deactivate

To create a bridge interface, click the Add icon at the top of the

column. The Bridge Add/Edit screen appears.

To create a virtual interface, click the Add icon next to the

corresponding bridge interface. The Virtual Interface Add/Edit

screen appears. See

Section 10.15 on page

To edit an interface, click the Edit icon next to it. The Bridge Add/

Edit screen or Virtual Interface Add/Edit screen appears

accordingly.

To remove an interface, click the Remove icon next to it. The ZyWALL

confirms you want to remove it before doing so.

To activate or deactivate an interface, click the Active icon next to it.

Make sure you click Apply to save and apply the change.

Click Apply to save your changes back to the ZyWALL.

Click Reset to begin configuring this screen afresh.

Chapter 10 Interfaces

Show Quick Links

Table of Contents