10.Pressure Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the idle air control solenoid valve. <Ref.
to FU(TURBO)-36, REMOVAL, Idle Air Control So-
lenoid Valve.>
3) Disconnect the connectors from pressure sen-
sor.
4) Remove the pressure sensor from throttle body.
PRESSURE SENSOR
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Replace the O-ring for the pressure sensor with
new ones.
Tightening torque:
1.6 N·m (0.16 kgf-m, 1.2 ft-lb)
G6M0095
EN0821
FU(TURBO)-35
FUEL INJECTION (FUEL SYSTEMS)