Subaru 2002 IMPREZA Service Manual page 1007

11) Move the clips, and then disconnect the fuel re-
turn hose (B) and jet pump hose (C).
12) Remove the nuts which install fuel pump as-
sembly onto fuel tank.
13) Take off the fuel pump assembly from fuel tank.
FUEL PUMP
B: INSTALLATION
Install in the reverse order of removal. Do the fol-
lowing:
(1) Always use new gaskets.
(2) Ensure sealing portion is free from fuel or for-
eign particles before installation.
(3) Tighten the nuts in alphabetical sequence
shown in the figure to specified torque.
Tightening torque:
4.4 N·m (0.45 kgf-m, 3.3 ft-lb)
S2M0060A
C: INSPECTION
Connect the lead harness to connector terminal of
fuel pump and apply battery power supply to check
S2M0061
whether the pump operates.
WARNING:
• Wipe off the fuel completely.
• Keep the battery as far apart from fuel pump
as possible.
• Be sure to turn the battery supply ON and
OFF on battery side.
• Do not run the fuel pump for a long time un-
der non-load condition.
FU(TURBO)-61
FUEL INJECTION (FUEL SYSTEMS)
S2M0063A
G2M0366