Powering On And Powering Off The Srx 210 Services Gateway; Powering On The Srx 210 Services Gateway; Powering Off The Srx 210 Services Gateway - Juniper SRX 210 Services Hardware Manual

5.
6.
Related Topics

Powering On and Powering Off the SRX 210 Services Gateway

This topic describes the following procedures:
1. Powering On the SRX 210 Services Gateway on page 73
2. Powering Off the SRX 210 Services Gateway on page 73

Powering On the SRX 210 Services Gateway

To power on the services gateway, insert the DC plug into the DC jack of the device
and insert the AC adapter into the power supply faceplate. The device starts as the
power supply completes its startup sequence. The Power LED lights during startup
and remains on steadily when the device is operating normally.

Powering Off the SRX 210 Services Gateway

To power off the services gateway, you can shut it down in one of the following ways:
Chapter 9: Grounding and Powering On the SRX 210 Services Gateway
Secure the grounding cable lug to the grounding points, first with the washers,
then with the screws.
Dress the grounding cable and verify that it does not touch or block access to
the services gateway components and that it does not drape where people could
trip on it.
Powering On and Powering Off the SRX 210 Services Gateway on page 73
Resetting the SRX 210 Services Gateway
Required Tools and Parts for Grounding and Powering On the SRX 210 Services
Gateway on page 71
SRX 210 Services Gateway General Safety Guidelines and Warnings on page 133
Graceful shutdown—Press and release the power button. The device begins
gracefully shutting down the operating system and then prints "press any key
to reboot."
Immediate shutdown—Press the power button and hold it for ten seconds. The
device immediately shuts down. Press the button again once to power on the
device.
Powering On and Powering Off the SRX 210 Services Gateway
73