Juniper SRX 210 Services Hardware Manual page 138

SRX 210 Services Gateway Hardware Guide
8.
Figure 22: Removing a Mini-PIM from the SRX 210 Services Gateway
9.
Related Topics
Installing a Mini-Physical Interface Module in the SRX 210 Services Gateway
NOTE: The Mini-Physical Interface Modules (Mini-PIMs) available on the SRX 210
services gateway are not hot-swappable. You need to power off the device before
removing or installing Mini-PIMs.
To install a Mini-PIM in an SRX 210 services gateway:
1.
2.
3.
118
Installing a Mini-Physical Interface Module in the SRX 210 Services Gateway
Grasp the screws on each side of the Mini-PIM faceplate and slide the Mini-PIM
out of the device as shown in Figure 22 on page 118. Place the Mini-PIM in the
electrostatic bag or on the antistatic mat.
If you are not reinstalling a Mini-PIM into the empty slot, install a blank faceplate
over the slot to maintain proper airflow.
Required Tools and Parts for Replacing a Mini-Physical Interface Module on the
SRX 210 Services Gateway on page 115
Removing a Blank Mini-Physical Interface Module Faceplate from the SRX 210
Services Gateway on page 116
Installing a Mini-Physical Interface Module in the SRX 210 Services
Gateway on page 118
Attach an ESD grounding strap to your bare wrist, and connect the strap to the
grounding point on the back of the device.
Unplug the power adapter from the device. Verify that the Power LED is off.
Grasp the screws on each side of the Mini-PIM faceplate and align the notches
in the connector at the rear of the Mini-PIM with the notches in the Mini-PIM slot
in the device. Then slide the Mini-PIM in until it lodges firmly in the device as
shown in Figure 23 on page 119.