Juniper SRX 210 Services Hardware Manual page 77

Before mounting an SRX 210 services gateway on a desk or other level surface:
NOTE: The vertical desk-mounting kit is not shipped with the device.
Related Topics
Preparing the SRX 210 Services Gateway for Wall-Mount Installation
You can mount an SRX 210 services gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Before mounting an SRX 210 services gateway on a wall:
Chapter 6: Preparing the SRX 210 Services Gateway for Installation
Verify that the site meets the requirements described in "Site Preparation
Checklist for the SRX 210 Services Gateway" on page 41.
Place the desk in its permanent location, allowing adequate clearance for airflow
and maintenance, and secure it to the building structure.
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see "Unpacking the SRX 210 Services Gateway" on page 51.
If you are mounting the services gateway horizontally on a desk, ensure that the
chassis is attached with the rubber feet. If you are mounting the device vertically
on the desk, make sure that the following parts are available in your vertical
desk-mounting kit for the SRX 210 services gateway:
Vertical stand
Screws
Site Preparation Checklist for the SRX 210 Services Gateway on page 41
SRX 210 Services Gateway Rack Requirements on page 45
Clearance Requirements for Airflow and Hardware Maintenance of the SRX 210
Services Gateway on page 46
Unpacking the SRX 210 Services Gateway on page 51
Preparing the SRX 210 Services Gateway for Rack-Mount, Desk-Mount, and
Wall-Mount Installation on page 55
Preparing the SRX 210 Services Gateway for Rack-Mount Installation on page 56
Preparing the SRX 210 Services Gateway for Wall-Mount Installation on page 57
Verify that the site meets the requirements described in "Site Preparation
Checklist for the SRX 210 Services Gateway" on page 41.
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see "Unpacking the SRX 210 Services Gateway" on page 51.
Verify that you have the following parts available in your wall-mounting kit for
the SRX 210 services gateway:
Wall-mounting brackets
Screws
Preparing the SRX 210 Services Gateway for Wall-Mount Installation
57