Using The Reset Config Button On The Srx 210 Services Gateway; Changing The Reset Config Button Behavior On The Srx 210 Services Gateway; Juniper Networks Technical Assistance Center - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide
Related Topics
Monitoring the SRX 210 Services Gateway Components using LEDs
The LEDs available on the services gateway display the status of various components.
Table 34 on page 122 describes the LEDs.
Table 34: Component LEDs on the Services Gateway
LED State
Status LED Green
Amber
Red
Alarm LED Red
Yellow
Off
122
Monitoring the SRX 210 Services Gateway Components using LEDs
Monitoring the SRX 210 Services Gateway Components using LEDs on page 122
Chassis and Interface Alarm Messages on the SRX 210 Services
Gateway on page 123
Monitoring the SRX 210 Services Gateway Power System on page 125
Using the Reset Config Button on the SRX 210 Services Gateway on page 127
Changing the Reset Config Button Behavior on the SRX 210 Services
Gateway on page 127
Juniper Networks Technical Assistance Center on page 128
Meaning
Indicates that the device is functioning
normally.
Indicates that the device is starting up.
Indicates that the device has failed.
Indicates a critical alarm.
Indicates a major alarm.
Indicates that there are currently no
alarms.
Possible Causes and Corrective
Actions
Normal Condition. No action is
required.
Normal Condition. No action is
required.
Contact JTAC. See "Juniper Networks
Technical Assistance
Center" on page 128.
Major alarm indicates a critical
situation on the services gateway
that requires immediate action.
See the topic about Monitoring the
Services Gateway using Chassis
Alarm Conditions.
Minor alarm condition requires
monitoring or maintenance. If left
unchecked, it might cause an
interruption in service or degradation
in performance.
See the topic about Monitoring the
Services Gateway using Chassis
Alarm Conditions.
Normal Condition. No action is
required.