Connecting An Srx 210 Services Gateway To The Cli Remotely; Connecting The Modem At The Srx 210 Services Gateway End; Connecting The Modem To The Console Port On The Srx 210 Services Gateway; Connecting To The Cli At The User End For The Srx 210 Services Gateway - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide
Connecting to an SRX 210 Services Gateway
You can connect to the services gateway using the J-Web interface or the CLI. This
section includes the following topics:
Connecting an SRX 210 Services Gateway to the J-Web Interface
If you plan to use the J-Web interface to configure the SRX 210 services gateway,
you must connect through one of the built-in Ethernet management ports.
When the services gateway is powered on for the first time, the system looks for a
DHCP server. If it does not find one, the system assigns an IP address within the
192.168.1.0/24
To connect to the J-Web interface through port 0 on the services gateway, see
Figure 15 on page 87.
86
Connecting to an SRX 210 Services Gateway
Connecting an SRX 210 Services Gateway to the J-Web Interface on page 86
Connecting an SRX 210 Services Gateway to the CLI Locally on page 88
Connecting an SRX 210 Services Gateway to the CLI Remotely on page 90
Connecting the Modem at the SRX 210 Services Gateway End on page 90
Connecting the Modem to the Console Port on the SRX 210 Services
Gateway on page 91
Connecting to the CLI at the User End for the SRX 210 Services
Gateway on page 92
subnetwork to any devices connected to the system.