Juniper SRX 210 Services Hardware Manual page 44

SRX 210 Services Gateway Hardware Guide
Key Features
The T1/E1 Mini-PIM provides the following key features:
LEDs
The T1/E1 Mini-PIM has three LEDs. Table 9 on page 24 shows the LED states.
Table 9: T1/E1 Mini-PIM LED States
LED Color Indication
Alarm Yellow
Loopback Yellow
Carrier Detector (CD) Green
Specifications
Table 10 on page 24 describes the physical specifications of the T1/E1 Mini-PIM.
Table 10: T1/E1 Mini-PIM Physical Specifications
Description
Dimensions (H x W x L)
Weight
24
SRX 210 Services Gateway T1/E1 Mini-Physical Interface Module
Integrated Channel Service Unit (CSU) or Data Service Unit (DSU) to eliminate
the need for a separate external device
56-Kbps and 64-Kbps operating modes
Independent internal and external clocking option
Alarm reporting with a 24-hour history maintained
Loopback, BERT, FDL (T1 only), and Long Buildout (T1 only) diagnostics
Multilink Frame Relay and Multilink PPP support
Complete configuration and management by CLI and J-Web
Status
On steadily
Off
On steadily
Off
On steadily
Off
Value
0.80" H x 3.75" W x 5.9" L
(2.0 cm x 9.5 cm x 14.5 cm )
0.18 lb (82g)
Description
Indicates that there is a local or remote
alarm; device has detected a failure
Indicates that there are no alarms or
failures
Indicates that a loopback or line state is
detected
Indicates that the loopback is not active
Indicates that the Mini-PIM link is up.
Indicates that carrier detect is not active