Connecting The Srx 210 Services Gateway To The Power Supply; Connecting Interface Cables To The Srx 210 Services Gateway; Organizing Interface Cables On The Srx 210 Services Gateway; Grounding And Powering On The Srx 210 Services Gateway - Juniper SRX 210 Services Hardware Manual

Connecting Interface Cables to the SRX 210 Services Gateway

You connect the interfaces installed in the services gateway to various network media.
Each type of interface on a services gateway uses a particular medium to transmit
data. You must configure each network interface before it can operate on the device.
To connect the interface cable to the device:
1.
2.
NOTE: External devices can be attached to console, Ethernet, or Gigabit Ethernet
ports.
Related Topics

Organizing Interface Cables on the SRX 210 Services Gateway

Arrange network cables as follows to prevent them from dislodging or developing
stress points:
Related Topics
Have ready a length of the type of cable used by the interface.
Insert the cable connector into the cable connector port on the interface faceplate.
Connecting the SRX 210 Services Gateway to the Power Supply on page 67
Organizing Interface Cables on the SRX 210 Services Gateway on page 69
Interface Cable and Wire Specifications for the SRX 210 Services
Gateway on page 161
Secure cables so that they are not supporting their own weight as they hang to
the floor.
Place excess cable out of the way in neatly coiled loops.
Use fasteners to maintain the shape of cable loops.
Connecting Interface Cables to the SRX 210 Services Gateway on page 69
Required Tools and Parts for Grounding and Powering On the SRX 210 Services
Gateway on page 71
Connecting Interface Cables to the SRX 210 Services Gateway
Chapter 8: Connecting the SRX 210 Services Gateway
69