Juniper SRX 210 Services Hardware Manual page 139

Figure 23: Installing a Mini-PIM on the SRX 210 Services Gateway
CAUTION: Slide the Mini-PIM straight into the slot to avoid damaging the components
on the Mini-PIM.
Tighten the screws on each side of the Mini-PIM faceplate using a 1/8 inch (3
mm) slotted screwdriver.
Insert the appropriate cables into the cable connectors on the Mini-PIM.
4.
If necessary, arrange the cables to prevent them from dislodging or developing
5.
stress points:
Secure the cables so that they are not supporting their own weight as they
hang to the floor.
Place any excess cables out of the way in neatly coiled loops.
Use fasteners to maintain the shape of the cable loops.
Reconnect the power adapter to the device. Verify that the Power LED glows
6.
steadily green after you press the power button.
Verify that the Mini-PIM LED on the system dashboard glows steadily green to
7.
confirm that the Mini-PIM is online.
Required Tools and Parts for Replacing a Mini-Physical Interface Module on the
Related Topics
SRX 210 Services Gateway on page 115
Removing a Blank Mini-Physical Interface Module Faceplate from the SRX 210
Services Gateway on page 116
Removing a Mini-Physical Interface Module from the SRX 210 Services
Gateway on page 117
CLI on the SRX 210 Services Gateway on page 121
Chapter 13: Replacing Mini-Physical Interface Modules on the SRX 210 Services Gateway
Installing a Mini-Physical Interface Module in the SRX 210 Services Gateway
119