Juniper SRX 210 Services Hardware Manual page 111

Table 26: Port Settings
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
5.
6.
7.
8.
9.
Related Topics
Connecting the Modem to the Console Port on the SRX 210 Services Gateway
To connect the dial-up modem to the console port on the SRX 210 services gateway:
1.
2.
3.
4.
5.
6.
7.
Chapter 10: Establishing Basic Connectivity for the SRX 210 Services Gateway
In the HyperTerminal window, enter
An response verifies that the modem can communicate successfully with the
OK
COM port on the PC or laptop.
To configure the modem to answer a call on the first ring, enter
To configure the modem to accept modem control DTR signals, enter
To disable flow control, enter
To save modem settings, enter
Connecting the Modem to the Console Port on the SRX 210 Services
Gateway on page 91
Connecting to the CLI at the User End for the SRX 210 Services
Gateway on page 92
Connecting an SRX 210 Services Gateway to the CLI Remotely on page 90
Turn off power to the services gateway.
Turn off the power to the modem.
Plug one end of the Ethernet cable supplied with your services gateway into the
console port (Figure 18 on page 92 shows the console cable connector) on the
services gateway.
Plug the other end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter
supplied with your services gateway.
Connect the serial port adapter to a separately purchased DB-9 female to DB-25
male adapter or other adapter appropriate for your modem.
Plug the modem adapter into the DB-25 connector on the modem.
Connect the modem to your telephone network.
Connecting the Modem to the Console Port on the SRX 210 Services Gateway
Value
9600
8
None
1
None
.
AT
AT&K0 .
.
AT&W
.
ATS0=1
AT&D1 .
91