Juniper SRX 210 Services Hardware Manual page 113

6.
7.
Related Topics
Configuring Basic Settings for the SRX 210 Services Gateway with J-Web Quick
Configuration
J-Web Quick Configuration allows you to configure basic settings. Figure 19 on page
93 shows the Quick Configuration page for basic setup.
Figure 19: Quick Configuration Set Up Page
To configure basic settings with J-Web Quick Configuration:
Configuring Basic Settings for the SRX 210 Services Gateway with J-Web Quick Configuration
Chapter 10: Establishing Basic Connectivity for the SRX 210 Services Gateway
An response verifies that the modem can communicate successfully with the
OK
COM port on the PC or laptop.
To dial the modem that is connected to the console port on the services gateway,
enter
ATDT remote-modem-number
connected to the console port on the services gateway is
.
ATDT 0013033033030
The services gateway login prompt appears.
Log in as the user root . No password is required at initial connection, but you
must assign a root password before committing any configuration settings.
Connecting the Modem at the SRX 210 Services Gateway End on page 90
Connecting the Modem to the Console Port on the SRX 210 Services
Gateway on page 91
Connecting an SRX 210 Services Gateway to the CLI Remotely on page 90
. For example, if the number of the modem
0013033033030 , enter
93