Configuring Basic Settings For The Srx 210 Services Gateway With J-Web Quick Configuration; Connecting An Srx 210 Services Gateway To The Cli Locally - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide
Figure 16: Ethernet Cable Connector (RJ-45/RJ-48)
NOTE: You must manually configure the IP address for the management port you
are using before you save your initial configuration. When you save the configuration
for the first time, you will lose the connection to the services gateway if you have
not manually configured the IP address. If you lose the connection through the
management interface, you must connect through the console port.
Related Topics

Connecting an SRX 210 Services Gateway to the CLI Locally

If you plan to use the CLI to configure the SRX 210 services gateway, you must
connect through the console port, as shown in Figure 17 on page 88.
Figure 17: Connecting to the Console Port on an SRX 210 Services Gateway
88
Connecting an SRX 210 Services Gateway to the CLI Locally
Connecting an SRX 210 Services Gateway to the CLI Locally on page 88
Connecting an SRX 210 Services Gateway to the CLI Remotely on page 90
Configuring Basic Settings for the SRX 210 Services Gateway with J-Web Quick
Configuration on page 93