Juniper SRX 210 Services Hardware Manual page 84

SRX 210 Services Gateway Hardware Guide
Figure 11: Installing the SRX 210 Services Gateway on a Wall
4.
5.
6.
7.
8.
64
Installing the SRX 210 Services Gateway on a Wall
Use a number–2 phillips screwdriver to install the screws that secure the mounting
brackets to the chassis.
If you are using wall anchors to support the chassis, install two pairs of anchors
on the wall, spaced 19 in. (48.3 cm) apart.
Have one person grasp the sides of the device, lift it, and position it on the wall.
Have a second person install two pairs of mounting screws through the bracket
holes on either side of the device to secure it to the wall.
Verify that the mounting screws on one side are aligned with the mounting
screws on the opposite side and that the device is level (see
Figure 12 on page 65).