Juniper SRX 210 Services Hardware Manual page 37

Table 6: SRX 210 Services Gateway Front Panel Components (continued)
Number Component
10 Universal Serial Bus
(USB) ports
11 Console port
Chapter 2: SRX 210 Services Gateway Hardware Components and Specifications
Location Description
Center of the front panel The USB ports have the
following characteristics:
Center of the front panel The Console port has the
following characteristics:
Usage
The USB ports can be used
as follows:
Consist of two ports
Function in the
following modes:
Low speed
Full speed
High speed
Compliant with USB
revision 2.0
NOTE: You must install and
configure the USB storage
device on the USB port to
use it as secondary boot
device. Also, the USB device
must have JUNOS installed.
Contact a customer service
representative for more
information.
The Console port can be
used as follows:
Consists of one port
Uses an RJ-45 serial
cable connector
Supports the RS-232
(EIA-232) standard
SRX 210 Services Gateway Front Panel
To support a USB
storage device that
functions as a
secondary boot device
in case of the internal
flash failure on startup,
if the USB storage
device is installed and
configured.
To provide the USB
interfaces that are used
to communicate with
many types of Juniper
supported USB storage
devices.
To provide the Console
interface
To function as a
management port to log
into a device directly
To configure the device
using the CLI
17