Physical Parameters; Basic Cli Commands For 3G Expresscard - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide
NOTE: Currently, PIN-protected SIMs are supported for all GSM cards.

Physical Parameters

The 3G ExpressCard has the following physical parameters:

Basic CLI Commands for 3G ExpressCard

Locking simcard
To enable locking in GSM sim cards, use the following command:
request modem wireless gsm sim-lock cl-0/0/8 enable pin
NOTE: After enabling the sim lock, the 3G ExpressCard continues to be in unlock
state until it is reset either by power recycling the services gateway or by plugging
out and reinserting the card back in to the device and rebooting the device.
Unlocking sim card
To disable sim lock, i.e. to remove the security on GSM sim cards, use the following
command:
request modem wireless gsm sim-lock cl-0/0/8 disable pin
Recovering sim card from puk state
While unlocking the sim if you continuously enter a wrong pin for 3 times, it will
enter puk state. To recover the sim back to normal, use the following command:
request modem wireless gsm sim-unblock puk
NOTE: PUK needs to be obtained from the cellular service provider.
34
SRX 210 Services Gateway 3G ExpressCard
code you provide in the services gateway configuration information, so that the
SIM can be unlocked without user intervention on each reboot/reset on the box.
Standard ExpressCard with 34 modules
Width — 34 mm
Thickness — 5 mm
Connector Pins — 26
Max power consumption — 1.3 W
Voltage supply — 3.3V (primary source) and 1.5V (secondary source)
<pin number>
<pin number>
pin
<puk pin number> <New pin number>