Built-In Ethernet Port For The Srx 210 Services Gateway - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide

Built-In Ethernet Port for the SRX 210 Services Gateway

The built-in Gigabit Ethernet ports,
of the SRX 210 services gateway are the ports through which you perform initial
device setup. The examples in this section use the
interface, but you can use any built-in Ethernet port for management. After the initial
configuration is complete, you can attach the built-in Ethernet port that you are using
for management purposes to the management network.
Before initial configuration, when the factory default configuration is active, the
device attempts to perform autoinstallation by obtaining a device configuration
through all its connected interfaces, including
as a DHCP client out of the built-in Ethernet ports.
If the services gateway does not find a DHCP server within a few seconds, it sets the
address of the ports as shown in Table 24 on page 84.
Table 24: Gateway Port Settings
Port
ge-0/0/0
(if used)
ge-0/0/1
through (if using Fast Ethernet ports as
fe-0/0/2 fe-0/0/7
management ports)
With the device temporarily acting as a DHCP server, you can manually configure it
with the J-Web interface. Any DHCP client host, for example, a PC or laptop computer,
directly connected to
NOTE: The DHCP functionality for initial setup is different from the configurable
DHCP server functionality of the services gateway during operation.
Once you connect your laptop or PC to
the address
complete the initial configuration of the device.
After you perform the initial configuration and commit it by clicking Apply or OK
on the Quick Configuration Set Up page, the configured device can no longer act as
a DHCP server. Therefore, to continue using the device as a management interface
you should configure the IP address of the interface as part of the initial configuration.
84
Built-In Ethernet Port for the SRX 210 Services Gateway
Built-In Ethernet Port for the SRX 210 Services Gateway on page 84
ge-0/0/0
, access the J-Web Quick Configuration Set Up page, and
192.168.1.1/24
through
ge-0/0/0 ge-0/0/1
ge-0/0/0
ge-0/0/0 . The services gateway acts
Address
192.168.1.1/24
NOTE: The services gateway becomes a DHCP server out of
the ge-0/0/0 port.
192.168.2.1/24
through
192.168.3.1/24 192.168.8.1/24
receives an address on the
ge-0/0/0 , you can use a Web browser to visit
, on the front panel
port as the management
network.
192.168.1.1/24