Port; Connector Pinouts For The Srx 210 Services Gateway Console Port; Connector Pinouts For The Srx 210 Services Gateway T1/E1 Mini-Physical Interface Module - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide
Table 40: Cable and Wire Specifications for Ports and Alarm Interfaces (continued)
Related Topics
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Ethernet Port
The port on the front panel labeled ETHERNET is an autosensing 10/100-Mbps
Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the services
gateway to a management LAN (or other device that supports out-of-band
management). Table 41 on page 162 describes the RJ-45 connector pinouts for the
Ethernet ports.
Table 41: RJ-45 Connector Pinouts for the Services Gateway Ethernet Port
Pin Fast Ethernet Signal
1 TX+
2 TX —
3 RX+
4 Not Connected
5 Not Connected
6 RX—
7 Not Connected
8 Not Connected
Related Topics
162
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Ethernet Port

Port

Cable Specification
Alarm relay Wire with gauge between
contacts 28-AWG and 14-AWG
(0.08 and 2.08 mm
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Ethernet
Port on page 162
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Console
Port on page 163
RJ-48 Connector Pinouts for the SRX 210 Services Gateway T1/E1 Mini-Physical
Interface Module on page 163
RJ-11 Connector Pinouts for the SRX 210 Services Gateway ADSL2 +
Mini-PIM on page 166
Interface Cable and Wire Specifications for the SRX 210 Services
Gateway on page 161
RJ-45 Connector Pinouts for the SRX 210 Services Gateway Console
Port on page 163
Cable/Wire Supplied
No
2
)
Gigabit Ethernet Signal
BI_DA+
BI_DA—
BI_DB+
BI_DC+
BI_DC—
BI_DB—
BI_DD+
BI_DD—
Maximum Device
Length Receptacle
None —