Juniper SRX 210 Services Hardware Manual page 38

SRX 210 Services Gateway Hardware Guide
Table 6: SRX 210 Services Gateway Front Panel Components (continued)
Number Component
12 Gigabit Ethernet ports
13 Fast Ethernet ports
SRX 210 Services Gateway Ethernet Ports LEDs
18
SRX 210 Services Gateway Front Panel
Location Description
Right side of the front The Gigabit Ethernet ports
panel have the following
characteristics:
Both Gigabit Ethernet ports
support PoE.
NOTE: This is applicable
only for PoE version of the
SRX 210 services gateway.
Right side of the front The Fast Ethernet ports
panel have the following
characteristics:
The first two Fast Ethernet
ports support PoE.
NOTE: This is applicable
only for PoE version of the
SRX 210 services gateway.
Usage
The Gigabit Ethernet ports
can be used as follows:
Consist of two fixed
ports
Labeled as port 0/0 and
port 0/1 on the front
panel
Use an RJ-45 connector
Provide link speeds of
10/100/1000 Mbps
Operate in full-duplex
and half-duplex modes
Support flow control
Support
autonegotiation
The Fast Ethernet ports can
be used as follows:
Consist of six fixed
ports
Labeled as port 0/2 to
port 0/7 on the front
panel
Provide link speeds of
10/100 Mbps
Operate in the
full-duplex and
half-duplex modes
Support flow control
Support
autonegotiation
To function as front-end
network ports
To provide LAN and
WAN connectivity to
hubs, switches, local
servers, and
workstations
To forward incoming
data packets to the
device
To receive outgoing
data packets from the
device
To provide LAN
connectivity to hubs,
switches, local servers,
and workstations
To forward incoming
data packets to the
device
To receive outgoing
data packets from the
device